Metric for the default route - social.technet.microsoft®.com
networking - In Linux, what metric has a route with no Since these routes are on different subnets, there's more involved here than just the metric. If originating traffic is on the 192.168.1.1 subnet, for instance, and there is a matching non-default route in your routing table, then that route will match via longest prefix match before the metric is ever considered. Assuming a non-default route is not matching, then having no metric should be What is Routing Metric Value - OmniSecu Cisco IOS Software has a limit of six equal-cost routes on the routing table, but some protocols set their own limitations. For example, EIGRP allows up to four equal-cost routes. For almost all Routing Protocols, the route with least metric is considered as best route. The Routing Table
Finally when a routers needs to route a packet, it will look at the routing table and use the route longest match prefix (subnet mask). For example, two routes are present in the routing table – 10.1.1.0/24 and 10.1.1.0/28, and a packet destined to 10.1.1.1 is received, the router will select the 10.1.1.0/28 route since it is route with the
$ ip route default via 10.0.0.1 dev wlp3s0 proto static metric 600 10.0.0.0/24 dev wlp3s0 proto kernel scope link src 10.0.0.73 metric 600 10.0.1.0/24 dev lxcbr0 proto kernel scope link src 10.0.1.1 169.254.0.0/16 dev docker0 scope link metric 1000 linkdown 172.17.0.0/16 dev docker0 proto kernel scope link src 172.17.0.1 linkdown 192.168.122.0/24 dev virbr0 proto kernel scope link src 192.168 Using the route Command - Networking Tutorial
In this case, the route going through R2 will have a metric of one, because only one router is in the path to the 10.0.0.0/24 network. The route going through R3 and R4 will have a metric of two. The first route will be placed in the routing table and used for packets sent to the 10.0.0.0/24 subnet.
Jul 03, 2017 · The metric cost value is just a cost that is relative to other costs in the table and is used when Windows decides between multiple routes that could reach the same destination. So, for example, if you wanted to add a route specifying that all traffic bound for the 192.168.35.0 subnet went to a gateway at 192.168.0.2 and you just wanted to use